Gerber Technology GERBERplotter Infinity 45 - Infinity Network Setup Interface

25
English
Figure 14. Infinity Network Setup Interface
6. Follow the on-screen instructions to assign a specific IP
address.
7. Reboot the plotter by turning power Off, then On.
8. Open Gerber Devices by selecting
Start/Settings/ControlPanel/Gerber Devices.
9. Click on the Plotter tab.
10. Scroll under Comm Port to select Com-Net.
11. Enter the IP address from your network administrator
under Host.
12. Verify that 9221 is entered under Port.
13. Select Gerber Infinity 85 under Type.
14. Select OK.
15. Verify that the plotter icon is in the system tray at the
bottom right corner of the display.