Gerhardt Vap 30 - 6 Operation; Safety Instructions; Priming the System

C. Gerhardt GmbH & Co. KG
20
VAPODEST 30
– Programme the semi master as described in the previous pa-
ragraph
After having confirmed program step 5 the following is shown
on the display:
– Press the „Run“ key to initiate the data transfer from
the semi master to the connected instruments
– After the termination of the data transfer the programming mode
automatically ends, and the display shows the start position:
Further information about GerBus® and GerLab® can either be
optained from C. Gerhardt GmbH & Co. KG or our appointed
dealer!