P.9
安裝說明 Installation Instructions 安裝說明 Installation Instructions
!
!
重要注意事項
WARNING!
儲水式電熱水器安裝並進行通水通
電測試後，如果不是繼續使用，而
是先擱置一段時間後再使用，測試
完畢必需進行以下程序：
1. 將電熱水器斷電斷水；
2. 將電熱水器內測試的水排清；
3. 當存放後需要正常使用前，必需將電熱
水器注滿水並確定滿水後，才可以通電
加熱，進入正常使用。
After initial installation and water
and electricity testings, if the storage
water heater will not be put to use
immediately, after testing is completed,
make sure to follow these instructions:
1. Disconnect water and power source;
2. Completely drain the residual water
3. When the water heater is nally put to
normal use, user MUST rst completely ll
up the water heater with water BEFORE
reconnecting the power source and
commencing heating.
注意：
對於水源是地下水以及（有可能海水倒灌
的）河水地區的使用者，必需嚴格遵照上列
程序，以確保熱水器正常運作。
NOTE:
If water source is from underground water
or near river area where seawater intrusion
is possible, user MUST COMPLY with all of
the above steps to ensure proper function of
water heater.
預留維修位置
Min. space for maintenance
≥200
≥300
≥80
≥200
!
!
安裝注意事項
INSTALLATION REQUIREMENT
ATTENTION: When installing the
water heater, must leave ample space
for future maintenance and repair.
The minimum requirements are:
1. at least 100 mm space from the ceiling
2. at least 200 mm on either side of the wall
3. at least 300 mm underneath the heater
注意：安裝熱水器時必須預留足夠空間
作日後保養和維修之用。
最少預留空間：
1. 距離天花最少80毫米
2. 距離兩邊牆壁最少200毫米
3. 爐底預留最少300毫米
To Next Page
Loading...
