German pool PAC-CH416-SC - Page 10

P.10
Installation Instructions
A. Remove Packing Materials
1. Remove all packing materials before using product for the rst time.
2. It is recommended to save the carton box and styrofoam packing for storing the product when not
in use.
Note:
• The are NO packing materials inside the product to remove. DO NOT disassemble the product
body.
• Properly dispose/recycle all packing materials.
• Handle the product gently, and keep it upright and level at all times. DO NOT set this product on
its side, front, back or upside down.
B. Install Exhaust Hose
1. Grasp both ends of the exhaust hose and gently pull to expand the hose.
2. Screw one end of the hose to the exhaust hose connector using a clockwise motion, until it is
rmly attached.
3. Screw the other end of the hose to the exhaust hose adaptor using a clockwise motion, until it is
rmly attached.
Note:
DO NOT attach additional hoses to extend the length, as it will decrease the cooling efciency and may
damage the product.
C. Connect Exhaust Hose To The Product
1. Align the exhaust hose connector with the slots on the exhaust hose fastener on the back of the
product.
2. Slide the connector downwards into the exhaust hose fastener until it is rmly attached.