P.11
1. Adjust the expansion panel to t the size of your window opening.
2. Open the window, and place the adaptor panel in the window opening.
3. Take out the buttery nut from the accessories bag, and unscrew the nut as shown in the diagram
below.
4. Thread the screw through the screw hole on the main adaptor panel, and screw on the buttery
nut, leaving a 2.5mm space.
Installation Instructions
D. Install Window Adaptor Kit
Note:
• Window adaptor kit is designed to accommodate either a vertical slide or horizontal slide window.
• If the window opening is shorter than the minimum length of the window adaptor kit, cut the end
without the hole until it is short enough to t in the window opening. DO NOT cut out the hole in
the window adaptor kit.
To Next Page
Loading...