German pool PAC-CH416-SC - Page 15

P.15
Operation Instructions
Mode Selection
1. When product is turned on, tap Mode Key to cycle among Cool Mode, Dry Mode, Fan Mode
and Heat Mode, the corresponding indicator light will light up constant.
2. After selecting your desired mode, tap Increase Key /Decrease Key to adjust
temperature, and tap Fan Speed Key to adjust fan speed (temperature is not adjustable in
Dry Mode or Fan Mode; fan speed is not adjustable in Dry Mode).
3. Tap Swing Key to start or stop Swing Function.
Mode Temperature Fan Speed LED Display
Cool Mode
Adjustable
(High/Medium/Low)
Dry Mode
Adjustable from
16 ºC-32 ºC
Shows current room
temperature
Shows set temperature
Low Fan Speed by default,
not adjustable
Fan Mode
Not adjustable
Shows current room
temperature
Adjustable
(High/Medium/Low)
Heat Mode
Not adjustable
Adjustable from
16 ºC-32 ºC
Shows set temperature
Adjustable
(High/Medium/Low)
Note:
• When in Cool Mode but the set temperature is higher than current room temperature, or when in
Heat Mode but the set temperature is lower than current room temperature, the product will not
run.
• When changing modes, the compressor will delay turn on/turn off for approx. 15-30 seconds.
Sleep Mode
1. In Cool Mode or Heat Mode, tap Sleep Key
to activate Sleep Mode, all indicator lights go dim.
2. In Sleep Mode, product runs in Low Fan Speed by default, fan speed is not adjustable;
temperature is adjustable from 16ºC-32ºC; and LED Display shows the set temperature.
Note:
• In Cool Mode, when user turns on Sleep Mode, set temperature will automatically increase by
2 ºC (at the rate of 1 ºC per hour) then kept constant; in Heat Mode, when user turns on Sleep
Mode, set temperature will automatically decrease by 2 ºC (at the rate of 1 ºC per hour) then kept
constant; this is for the purpose of saving energy.
• Sleep Mode is not available when using Dry Mode or Fan Mode.
• In Sleep Mode, tapping Mode Key or Sleep Key will exit Sleep Mode.