P.19
Operation Instructions
Manual Drainage
1. Turn off the product and unplug product from the socket.
2. Place a tray or container (not included with product) under the Condensation Drain Port located at
the bottom of the product’s backside.
3. Unplug the Condensation Drain Port plug to let the water run out. User may tilt the product slightly
to speed up drainage.
4. Re-plug the drain port after all the water has run out.
Note:
• Be careful not to let the water spill out when moving the product.
• If your container cannot hold all the water, please re-plug the drain port before the container is
full, in order to avoid spillage wetting the oor or carpet.
• Make sure the plug has been re-plugged rmly before restarting the product so the new
condensation will not spill out.
Continuous Drainage
1. Unplug the Continuous Drainage Outlet and connect the included drain hose (inner diameter
16mm) securely to the outlet.
2. Let the hose drain into a bucket. DO NOT immerse the hose end into water to advoid causing air
lock.
Note:
• It is recommended NOT to use continuous drainage when product is operating in Cool Mode to
ensure adequate water recycles in the unit to enhance the system’s cooling effect.
• It is recommended to use continuous drainage when product is operating in Heat Mode or Dry
Mode to avoid frequent drainage.
• Make sure the drain hose is not placed higher than the Continuous Drainage Outlet, and that the
hose is not bent.
Compressor Delay Turn-On Protection
Aside from the rst time the product is connected to the power source when the compressor may start
to run immediately, each time the product is turned off and the compressor stops running, the product
will activate a 3-minute delay turn-on safety mechanism whereby even if the product is turned on again
immediately, the compressor will not restart until after 3 minutes.
To Next Page
Loading...