50
51
RENTAL SERIES
ELECTRICAL GENERATOR
Image 16 - Placing in operation Image 17 - Caution with generator startup Image 18 - General warning
Image 19 - Undefined Warning Notice Image 20 - Electrical Hazard 230 Volts Image 21 - Electrical Hazard 400 Volts
Image 22 - Lifting point Image 23 - Possible battery leakage Image 24 - Electrical grounding
Image 25 - Noise output 90 dB Image 26 - Noise output 114 dB
Image 27 - Use of hearing protection required
Image 28 - Coolant Flush Image 29 - Oil draining Image 30 - Fuel draining
IMPORTANT
PLACING IN OPERATION:
1.
Make sure “Battery Isolator” switch is CLOSED.
2.
Check engine’s water and oil levels.
3.
Connect ground wires to a suitable point on the ground.
4.
Make sure electrical power circuit breaker is OPEN.
5.
Connect cables to connection terminals on circuit breaker.
6.
Start up ELECTRICAL GENERATOR.
7.
Make sure voltage and frequency are correct.
8.
Set electrical power switch to CLOSED position.
CAUTION
THIS ELECTRICAL
GENERATOR COULD
START UP WITHOUT PRIOR
WARNING.
To perform MAINTENANCE, switch the
BATTERY ISOLATOR to the OPEN position.
BATTERY ISOLATOR
Image 31 - Battery isolator
To Next Page
Loading...