GET SMART SOS - Device Installation and Setup; Insert the Battery; Decide Device Mounting Location; Fix the Device to the Vehicle

8
SMART SOS USER MANUAL
3. INSTALLING AND SETTING UP
THE DEVICE
1. INSERT THE BATTERY taking care not to damage the rubber washer protecting the cap and the holder at the
back of the SMART SOS device.
2. DECIDE WHERE THE DEVICE IS TO BE FIXED and turn on the engine. Place the device on the spot where it is
to be fixed, pressing with two fingers at the sides of the display. Without pressing the button and with the engine
idling, the device should switch on automatically and begin to count the engine-hours.
N.B.: IF THE DEVICE DOES NOT SWITCH ON WITH ENGINE IDLING, TRY CARRYING OUT A CALIBRATION USING
THE GET SMART SOS APP.
TRIPLE CLAMP CHASSIS (AWAY FROM SOURCES
OF HEAT OVER 70°C /158°F)
UNDER-SEAT COMPARTMENT / CHASSIS
IN POSITION PROTECTED FROM
MUD AND KNOCKS
3. FIX THE DEVICE, after first cleaning the bike surface before installation and gluing with double-sided tape
only at a temperature of over 10°C / 50°F. We recommend completing fixing of the device with two straps.
>10°