Getac EX80 - Using the Hand Strap

12
Using the Hand Strap
NOTE: You cannot install the hand strap if the stylus holder is installed.
This hand strap provides three functions for your Tablet PC: rotatable hand
grip, kickstand, and stylus holder.
Installation
1. Insert the end belts of the hand strap through the two slots.
2. To fasten each belt:
Fold the belt over and insert it through the slide adjuster, going from
underneath the inner side of the adjuster (

).
Fold the belt over, insert it through the outer side of the slide adjuster,
and pull it tight (

).
3. Make sure the hand strap is positioned at the center. If it is not centered,
adjust the belts until it is.