67
On the Use of the RF Device
USA and Canada Safety Requirements and
Notices
Radio Frequency Interference Requirements and SAR
This device meets the government’s requirements for exposure to radio waves.
This device is designed and manufactured not to exceed the emission limits
for exposure to radio frequency (RF) energy set by the Federal Communications
Commission of the U.S. Government.
This device complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
EMC Requirements
This device uses, generates and radiates radio frequency energy. The radio
frequency energy produced by this device is well below the maximum
exposure allowed by the Federal Communications Commission (FCC).
This device complies with the limits for a Class B digital device pursuant to
Part 15 subpart C of the FCC Rules and Regulations. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference
that may cause undesired operation.
Any changes or modifications not expressly approved by the manufacturer
could void the user’s authority to operate the equipment.
The FCC limits are designed to provide reasonable protection against harmful
interference when the equipment is installed and used in accordance with
the instruction manual and operated in a commercial environment. However,
there is no guarantee that interference will not occur in a particular
commercial installation, or if operated in a residential area.
To Next Page
Loading...
Need help?
General
