EasyManua.ls Logo

Getac VR-X20 - Regulatory Compliance; USA Regulations (FCC); Canada Regulations

Getac VR-X20
8 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6
Do not recharge the battery if it is not a rechargeable type.
Do not leave the battery in a vehicle exposed to direct sunlight for a long
period of time with doors and windows closed.
For memory backup battery: There is danger of explosion if the battery is
incorrectly replaced. Replace only with the same or equivalent type. Consult
qualified service personnel when replacement is required.
USA Regulations
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
To assure continued compliance, follow the attached installation instructions
and do not make any unauthorized modifications.
FCC Note:
This equipment has been tested and found to comply with the limits for a class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment
is operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy, and if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at
his own expense.
Warning:
To assure continued FCC emission limit compliance, the user must only use shielded
interface cables when connecting to external units. Also, any unauthorized
changes or modifications to this equipment could void the user’s authority to
operate this device.
Canada Regulations
This device complies with Industry Canada’s licence-exempt RSSs. Operation is
subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux
appareils radio exempts de licence. L’exploitation est autorisée aux deux
conditions suivantes :
(1) l’appareil ne doit pas produire de brouillage, et
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d’en compromettre le fonctionnement.