8
11. Bring the PCI/PCIe printed circuit board near the cabinet so that you can
connect the male connector of the 10-pin power cable to the motherboard.
(See the dotted circle below for the connector position.)
12. Align and fit the PCI/PCIe printed circuit board back into place.
Note that the 10-pin power cable should go through the notch
at the edge of the board.
13. Secure the board by fastening 19 screws as indicated below.
Find the matching screws from the Expansion Unit package.
Ref Screw Type Quantity
A M2.0L4 15
B M2.6L20 4
Notch
To Next Page
Loading...
