9
14. Connect the two 3-pin fan power cables to the PCI/PCIe printed circuit board.
(See the dotted circles below for the connector positions.)
15. Now the Expansion Unit is ready for add-on cards to be installed. (See Section
4 for add-on card installation instructions.)
Part 4
16. Follow steps 1 to 7 in Section 5 to reassemble the Expansion Unit.
Part 5
17. The Expansion Unit has two battery compartments for two battery packs; each
is installed in the same way.
Locate the battery compartment and open its cover. Noting the orientation,
insert the battery pack all the way into the compartment. Using the ribbon
strip, slide the locking latch toward the locked position ( ). The latch should
click into place.
18. Locate the optical disc drive compartment and open its cover. Noting the
orientation, insert the drive all the way into the compartment. Pull the ribbon
strip downward to lock the dive in place.
To Next Page
Loading...
