11
Instructions for use5018610-00 Rev.D
Edition 0703
Operating instructions
Loading goods to be washed into the machine
• Load the items to be washed on to the trolley and run the trolley into the
machine. Examples showing how to load the trolley are shown on the goods
positioning sign.
NOTE:
Maximum weight of items to be washed and wash trolley:
46-2: 35 kg
46-4: 50 kg
46-5: 60 kg
• Make sure that the washer arms can rotate freely without touching the goods.
• Close the door.
A fine filter must be used when cleaning and disinfecting tubular instruments
with a passage smaller than 1 mm, to prevent particles getting stuck in the
instruments. Blocked or reduced water flow may result in cleaning and
disinfection failing to take place.
Choose a program
• Choose a program in one of the following ways:
- Press one of the program selection buttons 1 -6
- Press S. The display now shows “CHOOSE PROGRAM”.
Press S again.
Choose a program from the list with H and J.
Press S to confirm your choice.
You can see the machine programs on the separate program sheet.
• Press V. A yellow lamp flashes for 10 seconds. During this time, the program
can be aborted by pressing V again.
While a program is running
While the program is running, a yellow lamp at N is lit and the program phase (eg
“Rinse”) and the current temperature are shown on the display. Press S to see
how much time remains.
When the program is complete
• When the program is complete, a green lamp lights up at N. The door (on the
clean side if the sterilizer has two doors) is unlocked and can be opened.
If the items are still hot after a program, handle them with care to avoid burns.
• Empty the machine (and if the machine has double doors, close the clean-side
door).
• If the same program is to be used again, there is no need to select the program
again. Simply press V immediately.
Note:
The display switches to standby mode after 30 minutes and returns automatically when a
program is started or selected.
Operating instructions
To Next Page
Loading...
Need help?
General
