Getinge 46-2 Instructions For Use

16
Instructions for use
5018610-00 Rev.D Edition 0703
Fault codes in the master supervisory system (option)
The fault codes indicate that the monitoring system has detected serious fault in the
machine or in the current wash program. All fault codes in the supervisory system
must be acknowledged on the washer disinfector’s control panel. The fault must be
put right by an authorized service technician. When the fault is pur right, the fault
code is reset automatically.
The following fault codes may occur:
Fault code Description of fault
F00 Faulty (controlling) temperature sensor in washing chamber
F01 Faulty (independent) temperature sensor in washing chamber
F02 Low pressure from circulation pump.
F04 Incorrect temperature in washing chamber. (Sensor fault)
F05 Low pressure from circulation pump.
F06 High pressure from circulation pump.
F08 Not enough detergent 1 dosed.
F09 Not enough detergent 2 dosed.
F10 Not enough detergent 3 dosed.
F11 Not enough detergent 4 dosed.
F13 High conductivity.
F14 Incorrect disinfection time.
F15 Disinfection temperature lower than set temperature.
F16 Fault message from control system
F17 Power outage, emergency stop
Fault indications

Getinge 46-2 Specifications

General

Brand	Getinge
Model	46-2
Category	Washer
Language	English