Getinge 46-2 Instructions For Use

15
Instructions for use5018610-00 Rev.D
Edition 0703
Fault code Description of fault
F09 Clean-side door does not lock within 10 seconds of program start or if
the door is opened while a program is running.
F10 Clean-side door does not unlock within 10 seconds of the end of a
program.
F15 Not enough detergent 1 dosed.
F16 Not enough detergent 2 dosed.
F19 Not enough detergent 3 dosed.
F20 Not enough detergent 4 dosed.
F23 High conductivity.
F24 Low pressure in drying unit.
F25 High pressure in drying unit.
F26 Low pressure from circulation pump.
F27 High pressure from circulation pump.
F28 Low temperature in drying unit.
F30 Faulty (controlling) temperature sensor in washing chamber
F31 Faulty (independent) temperature sensor in washing chamber
F32 Faulty temperature sensor in drying unit.
F33 Incorrect temperature in washing chamber. (Temperature too low
because of a heating fault.)
F34 Incorrect temperature in washing chamber. (Sensor fault)
F35 Not used.
F36 Fault message from independent supervisory system; see under Fault
codes in independent supervisory system
F37 Incorrect temperature in washing chamber. (Temperature too high
because of a heating fault.)
F38 Disinfection temperature lower than set temperature.
Fault indications

Getinge 46-2 Specifications

General

Brand	Getinge
Model	46-2
Category	Washer
Language	English