Introduction Servo-i Ventilator System
2 - 2 Service Manual Revision 02
2
Main units
The Servo-i is available in different main
configurations:
• Infant
• Adult
• Universal
These main configurations are as standard equipped
with a number of ventilation modes suitable for each
patient category. Further ventilation modes can be
installed via software Option Upgrades.
The Servo-i can be divided into the following main
units:
• User Interface. The User Interface contains all
controls used to set the ventilation and monitoring
parameters. Ventilation parameters as well as other
important information are shown on the User
Interface display.
• Patient Unit. The Patient Unit contains pneumatics
and electronics for gas supply to the patient.
Power supply and battery back-up is also
contained in the Patient Unit.
The Control cable connects the User Interface and
the Patient Unit.
The Servo-i shown in the illustration is mounted onto
the optional Servo-i Mobile cart.
Patient Unit
User Interface
Servo-i
Mobile Cart
To Next Page
Loading...
