5
CONNECTION
GUIDELINES FOR CONNECTION AND USE
The connection should be fullled by a qualied specialist or a manufacturer’s representative!
If you connect a lter independently, follow the prompts accurately
All lter housing underwent tightness and hydro shock tests, so that there is could be
water inside lter housings
It’s not recommended to disassemble factory connections if not urgent
PREPARATION TO CONNECTION
1. Before set-up, keep the lter for min.3 hours at room
temperature
2. Before the works start, shut off the water feed to the
place of connection (g.1) and depressurize, having
opened a faucet.
3. Before the installation, make sure that housings are
safely tighten up*. In case needed tight them up.
4. Check that inlet and outlet ttings are set correctly (facet
for a wrench is vertical). If necessary, turn ttings to x
them into the housing.
1
*
The manufacturer reserves the right to make design and packaging of a minor improve without showing in this manual.
SCOPE OF SUPPLY
Assembled lter
Wrench for a housing
Wrench for a bottom valve
Pure water tap with everything for
connection
Connection pipe 1/4”
Triple adaptor
Manual
Package
* Check reliability of housings tightness periodically. In case needed they should be tighten.
Warning! The position of a vertical label in the center of a lter face surface doesn’t guarantee the leak-tightness
of the connection. The label position may change when the threaded connection of the housing is tightened.
HOW TO CONNECT
The system is connected to a cold water main line.
1. Extract the lter from the packing case.
2. Remove shipping plugs. Press the plastic ring at the
connecter with a screw-driver end and easily extract
the plug (Fig. 1).
3. Cut a connection pipe from a complement in two and
connect each half to a lter inlet and outlet.
4. Fix a lter to a place convenient for usage. It is
recommended to x a lter on vertical surface at a
height of min. 15 cm from a floor to replace cartridges
easily.
1
To Next Page
Loading...
