GEZE GC 363 R - Product Liability; Safety; Intended Use; Safety Notices

Safety GC 363 R / SF
4
Product liability
In compliance with the liability of the manufacturer for his products as
dened in the German “Product Liability Act”, compliance with the infor-
mation contained in this brochure (product information and intended use,
misuse, product performance, product maintenance, obligations to provide
information and instructions) must be ensured. Failure to comply releases
the manufacturer from his statutory liability.
1 Safety
1.1 Intended use
The combined sensor GC 363 may only be used to activate and protect
automatic sliding doors and curved sliding doors with GEZE drives.
The minimum object size corresponds to the reference object CA accord-
ing to DIN 18650 or 16005 both upright and lying down. The sensor can be
used to secure automatic sliding doors against impact and trapping of the
human body.
GC363 R
(in the direction
ofemergency exit)
GC363 SF
1.2 Safety notices
à The prescribed mounting, maintenance and repair work must be per-
formed by personnel authorised by GEZE. Any attempts at repairs by
unauthorised personnel cancel the factory guarantee.
à The device may only be operated with safety extra-low voltage (SELV)
with electrically protective separation.
à The country-specic laws and regulations are to be observed during
safety-related tests.
à Make sure that the cover of the drive is tted correctly and earthed.
à If unauthorised changes are made to the system, GEZE cannot be held
liable in any way whatsoever for any resulting damage, and the approval
for use on escape and rescue routes ceases.