To Next PageTo Next Page
Need help?Do you have a question about the GEZE ST220 and is the answer not in the manual?
General| Brand | GEZE |
|---|---|
| Model | ST220 |
| Category | Controller |
| Language | English |
Information regarding the manufacturer's liability for products as defined in the German Product Liability Act.
Information on software version validity for chain and spindle drives, and locking drives.
Specifies the intended use of the service terminal ST220 and service case for IQ windowdrives.
Mandatory safety requirements for installation, maintenance, repair, and adherence to country-specific regulations.
Details the physical components of the ST220 service terminal, identified by numbered positions in an illustration.
Explains the function of each button on the ST220 service terminal, including navigation and confirmation keys.
Step-by-step instructions for connecting the ST220 service terminal to the service case and powering it on.
Details menu items related to opening and closing functions, including unlock/lock operations.
Introduces the parameter section of the menu, covering various operational settings.
Details parameters related to drive configuration, input signals, and device positions.
Covers diagnostic information, internal values, distance travelled, and operating duration.
Explains how to manage messages, retrieve drive data (type, serial number), and control settings.
Covers settings for factory defaults, learning modes, and language selection.
Instructions on how to lock and unlock a locking drive using the 'lock/unlock' menu item on the ST220.
General instructions for setting drive parameters using the ST220, including menu navigation.
Details parameters for ventilation and alarm speeds, noting limitations and display differences.
Explains setting ventilation and alarm stroke parameters and their interdependencies.
Defines the relief stroke as the extent to which load is relieved after reaching the closing position.
Explains the reversing stroke, which defines drive reversal upon obstruction before reaching an end position.
Describes parameters for ventilation braking and acceleration ramps, including warnings about high expediting values.
States that alarm acceleration and braking parameters cannot be set but are only displayed.
Explains the closing position force parameter, its impact on airtightness and lifespan, and requires specialist setting.
Details self-locking and dead-man modes for push button operation of window drives.
Explains the choices for stopping window movement: same key, different key, or any key.
Allows switching locking drives between active and inactive states, and handling defective drives.
Describes the adjustable range for LO parameter stroke based on the connected locking drive.
Details the adjustable range for LO parameter force, proportional to the locking drive's maximum force.
Specifies the adjustable range for LO parameter speed for locking/unlocking, noting alarm override.
Table listing parameters, menu levels, and setting ranges for Slimchain, Powerchain, and E250 NT drives.
Table detailing parameter values for LO status, stroke, speed, and force for E90x and Powerlock drives.
Explains using drive values for troubleshooting, retrieving current/last cycles, and deleting data.
