2202 – 2304 Wasserdestillierapparate aus Glas
Glass Water Stills
Seite 10 von 28 Rev.02
1. Before installation
The information given in the present manual must by all means be carefully read and
observed. Only then can a perfect functioning of the Shaking Water Bath be guaranteed.
Vital information within the manual are emphasized in bold letters.
Safety precautions are additionally marked with the following symbols
Warning of hot liquids and steam
Warning of hot surfaces
Warning of dangerous electrical voltage
A free of charge guarantee repair cannot be granted for defects due to improper installation
or handling.
In order to protect the glass parts of the Water Stills during transport, the interior of the still is
filled with packing material, all free openings are covered with tape. These transport
protections have to be removed before installation.
2. Location of the Water Still
The unit is suitable for both bench and wall mounting. It is only suitable for indoor use.
If the unit is to be placed on a bench, place on solid, even and level surfaces only.
If the unit is to be mounted on a wall, check the carrying capacity of the wall in connection
with the total weight of the unit (appliance plus water filling, see technical data).
There are two keyholes for wall mounting at the back of the water still. Place two fastening
screws in the wall in the distance of the two keyholes and nest the still on the keyholes.
The unit is not suitable for use in explosion endangered surroundings, eg during
anaesthesia with inflammable gas or steam types!
3. Voltage
Main switch of the water still must be in OFF position.
Mains voltage and voltage stated on the name plate at the left-hand side of the unit
must be identical.
If this applies, unit can be connected.
To Next Page
Loading...