To Next PageTo Next PageHow to disable 1-Key mode on Ghost Controls AXWK Keypad?
If any key opens or closes the gate without entering a PIN, ensure the ‘1-Key’ button LED (Green) is off. If it's on, the keypad is in ‘1-Key’ mode. To disable it, press the ‘1-key’ button, enter the PRIMARY PIN, and press the SEND button. The ‘1-Key’ button LED should turn off.
What to do if Ghost Controls AXWK Keypad gives 3 long beeps follow by 2 short beeps?
If the keypad emits 3 long beeps followed by 2 short beeps when you press any key, it indicates that the keypad is still in the factory default setting. You should complete the steps in ‘PROGRAMING THE KEYPAD FOR THE 1ST TIME’.
What to do if Ghost Controls AXWK gives 2 long beeps with flashing LEDs?
If the keypad gives 2 long beeps with all the LEDs flashing twice randomly or when you use the keypad, it means the keypad is performing a power on check when the battery is first installed. Check and replace the batteries if necessary.
What to do if Ghost Controls AXWK beeps 2-times but will not open?
If you enter a PIN, and the gate opener beeps twice but doesn't open, it indicates that VacationMode is enabled on the gate. You can disable VacationMode or turn the gate controller off and then back on.
What to do if Ghost Controls AXWK Keypad beeps 2-times but will not close?
If you enter a PIN, and the gate opener beeps twice but doesn't close, it indicates that PartyMode is enabled on the gate. You can disable PartyMode or turn the gate controller off and then back on.
Instructions for installing two C-size alkaline batteries into the wireless keypad.
Essential steps to program the keypad, including setting a primary PIN and learning the remote.
Procedure to test the primary PIN to verify the keypad operates the gate correctly.
Recommended placement for the keypad, including distance from the gate and visibility.
Steps to add additional standard, time-based, and use-based access PINs.
Procedures for deleting a single access PIN or all access PINs from the keypad.
Instructions on how to change the 4-digit primary PIN for the keypad.
Guide for re-programming the keypad when a remote transmitter is replaced or its code is changed.
How to enable and disable PartyMode to keep the gate open and suspend autoclose.
Enabling and disabling PartyMode Secure or 1-Key mode for guest access without a PIN.
Steps to enable and disable Vacation Mode, which keeps the gate closed and denies RF access.
Instructions for performing a factory reset when the primary PIN is forgotten.
Answers to common questions regarding keypad operation, LEDs, and battery issues.
General| Brand | Ghost Controls |
|---|---|
| Model | AXWK |
| Category | Keypad |
| Language | English |
