GHOST
User Manual Status 04/2009 // Spec 2010
7.57
Move the saddle to the desired position.
• For saddle clamps with one bolt: Tighten the clamping bolt to the prescribed
torque again. Ensure that all loosened parts engage with one another again
correctly.
• For saddle clamps with two bolts: Turn the bolts alternately by a quarter to
half a turn until the prescribed torque is reached.
• For details of the prescribed tightening torque, please refer to the table in
chapter 3.2.
• Different tightening torques may be specified for some saddle posts. If these
are not listed in the table or directly on the saddle post, please contact your
dealer.
To Next Page
Loading...
