GHOST
User Manual Status 04/2009 // Spec 2010
10.93
Danger of material damage!
Hydraulic brakes must never be actuated after removal of the wheel!
Should your bike have disc brakes, please use the prescribed transport locking
devices provided for transport after removal of the wheel.
Remove these only immediately before installing the wheel again.
Observe the component user manual provided.
Danger of personal injury and material damage!
Bikes with rim brakes only:
The brake blocks may be twisted by the tyres during removal and installation of
the wheels.
Pay attention to the correct position of the brake blocks after installation
of the wheels (see chapter 6.8).
If they are not in the correct position, contact an approved workshop
immediately.
You may remove the wheels from your bike for transport and install them again after transport if
they are fitted with quick-release axles.
If your bike has rim brakes, pay attention that the position of the brake blocks
is not changed by the tyres. This could easily happen with large-volume tyres.
If the tyre does not fit easily between the brake blocks, release a
corresponding amount of air. Inflate the tyres again after installation to the
correct tyre pressure.
10.1.1 All categories except RACE Series
First remove the front wheel:
1. Release the rim brake.
a) On rim brakes with cable (e.g. from Shimano):
• Press the brake pads together with one hand and unhook the cable guide
from the bracket with the other.
To Next Page
Loading...
