Giant Crest 34 - Page 11

11
4
置入 LSC 調整軸，往下壓至正確位置。
Insert the LSC adjustment knob and adjust into
into the correct position.
5
在 Pin 的 180 度地方置入鋼珠及彈簧。
Carefully place the steel ball bearing and spring
into the 3 o'clock position, 180 degrees from
the silver pin.
6
阻尼側上蓋上油。
在 Pin 的逆時針方向 120 度的位置壓入阻尼側
上蓋。
Apply grease to the LSC cap and clip back into
place 120 degrees counterclockwise from the
silver pin.