Giant Crest 34 - Air Spring and Damper Side Maintenance

30
氣壓側及阻尼側保養 Air Spring and Damper Side Maintenance
1
分離上叉腳及下叉腳。註：請參考上下叉拆解章節
Disassemble upper and lower leg. Note: Refer upper/lower leg disassembly section.
2
拆解氣壓室及阻尼側。請參考氣壓室與阻尼側拆解章節
Refer to air spring side and damper side disassembly section to disassemble air spring and
damper.
3
1、清潔活塞組、螺絲、氣壓墊塊及氣壓內管。
2、檢視 O-ring/X-ring 磨耗的情況，浸泡至 Mobil SHC 627，必要時，請更換 O-ring/X-ring。
請參考 O-ring/X-ring 指南
1. Clean the piston set, nut, air spring token set and inside of air chamber.
2. Check the O-ring/X-ring for wear and tear. Soak the O-ring/X-ring in Mobil SHC 627
Other oils may be used, please check with Giant ASQA for confirmation. Replace the O-
ring/X-ring if necessary. For reference, consult the O-ring/X-ring indication section.
4
確認阻尼棒 Lockout 的功能或更換阻尼棒。註：請參閱更換阻尼棒章節
Check the damper lockout function and replace the damper cartridge if necessary. Note:
Refer to the damper cartridge replacement section for directions.
5
參考組裝流程組裝前叉。
Refer to fork assembly
section to re-assemble the fork.