25
1、標記螺絲位置①。
2、拿起上蓋，將墊片、塑膠襯套置入，襯套開口的位置需跟標記位置對齊②。
3、將彈簧放入上蓋③。
4、對齊塑膠襯套開口位置裝上蓋④。
1. Mark the bolt location①.
2. Remove the top cap and place the washer and plastic bushing in the nut. The gap of plastic
bushing should be aligned with the location mark②.
3. Put the spring in the top cap③.
4. Assemble the spring with the gap of the top cap aligning with the gap of plastic bushing④.
手指壓住上蓋並鎖緊上蓋螺絲，扭力值
1.2Nm。
Gently press the top cap with your thumb and
tighten the bolt to 1.2Nm.
To Next Page
Loading...
