Giant Crest 34 - Page 5

5
3
用 6 號六角板手拆下氣壓側及阻尼側底部螺
絲
Using a 6 mm hex, remove the bottom bolts of
the air spring and damper sides.
4
先把 LSC 調至 Open 的位置，將螺絲旋入 2~3 圈，使用膠槌敲打，分離下連桿與下叉腳
Open LSC (low speed compression) knob. Loosen the bolt two or three turns and use a plastic
mallet to gently tap it out.
5
取下螺絲，分離連桿及下叉腿
Remove the
bolt and separate the connecting rod and lower leg.
Se
6
取出油泡棉，浸泡至 Mobil SHC 627。 Remove sponges and soak in Mobil SHC 627. Other
oils may be used; please check with Giant ASQA for confirmation. Never use alcohol to clean.