23
Selecting an Extra Option
How to Use It
Option Description
Add-on to
cycles
This function makes the water temperature of the last rinse of a
selected cycle reach approximately 70 °C.
When selected, the button remains lit and the indicator begins to
ash when the last rinse is started, until the temperature is reached.
When the temperature is reached, the indicator stops ashing and
remains lit. If a program that does not allow you to Sanitise is
selected, the option is automatically cancelled.
The cycle time will be extended until the proper temperature is
reached and, during the increase of temperature, the washing step
proceeds.
This option can only be enabled or disabled when the appliance is
in standby mode.
Auto
Pots
ECO
This function postpones the start of the wash for a certain time.
When selected, the button and the Delay Start indicator remain
lit on the panel, and the display presents the programmed time.
Each touch on the button increases the time for the beginning of
washing in 3 hours, and the maximum time is 12 hours. The next
tap after the maximum time cancels the option Delay Start. To start
the countdown to the start of the washing, press Start/Pause.
The programmed time is presented on the display and the Start/
Pause button stops blinking and remains lit on the panel. Note that
the display shows only the full hours. For example, if there are 30
minutes till the end of the scheduled time, the display will continue
displaying “1H” (one hour) until the end of the countdown.
When the scheduled time for the begin of the washing ends, the
Dishwasher sounds a beep, the button Delay Start on the pane is
switched off, the display begins to display the total time of the cycle
and the washing process is started.
If the washing cycle is changed after the option Delay Start is
programmed, the display will present the time for 5 seconds and
then shows again the programmed time for the beginning of the
washing.
To cancel the time scheduled for the option Delay Start and start the
washing process immediately, simply press Start/Pause.
The countdown of the programmed time with the option Delay Start
will not pause if the door of the Dishwasher is opened. However, if
the door is open at the end of the countdown, the Dishwasher will
not start the washing process.
Any
cycle
To Next Page
Loading...