29
If there is overow of water, turn off the faucet water supply before
calling the Electrolux Service Authorized.
If there is water in the collecting tray due to the spill or a small leak, the
water must be removed before the dishwasher is switched on again.
Errors codes
When there is some problem with the dishwasher, the appliance beeps for 30 seconds, stops
working, drains water, and the display shows the error code.
Codes Meanings Possible Causes
E1 Too much time for the
water supply (more than 4
minutes).
The faucet is closed.
The water inlet is blocked.
Low inlet water pressure.
E4 Overowing water. Excessive use or unsuitable detergent.
Dishwasher not level.
Excess in the supply of water.
Drainage is insufcient due to a defect in the
drain pump.
Ducts or connections broken.
E9 Control panel powered
more than 30 seconds.
Water, any object or dirt is obstructing some
button on the control panel.
When this happens, you need to dry or
clean the control panel, eliminating the
obstruction on the buttons. After the panel
dries completely, the error code is switched
off in the display and the dishwasher returns
to normal function.
To Next Page
Loading...