24
To start the washing, press the Start/Pause button
Be careful when you open the door during the wash to prevent burns
due to hot water.
How to Use It
Press the Start/Pause button to start the cycle.
During the cycle, it is not possible to touch the buttons (except Start/Pause and On/Off). If
you touch any button that is not allowed, the Dishwasher will emit a beep to inform you that
the programming was not accepted.
If you try to start the wash cycle while the door of the Dishwasher is open, the appliance will
emit a beep, it will not start the washing process and the Start/Pause button will start ashing
on the panel.
Pausing a wash cycle
To pause a cycle, simply touch the Start/Pause button or open the door of the Dishwasher.
In this case, the time stops on the display and the Start Pause button will start ashing on
the panel.
To continue through the washing cycle, close the door of the Dishwasher and press the Start/
Pause button. The washing cycles resumes after 5 seconds.
Changing the Wash Cycle
To change the washing cycle, press and hold the button of the cycle in progress for 2
seconds. Then the cycle will be cancelled and the display will return to standby mode, with
the selected Smart cycle. Select the new cycle and touch Start/Pause.
The new selected cycle starts from the beginning.
To add an item after the start of the cycle
You can add a item to the Dishwasher at any time before the compartment of the detergent
opens:
1
o
Open the door a little to stop the wash.
2
o
After the spray arm stops, open the dor completely.
3
o
Load the items.
4
o
Close the door. The dishwasher resumes after 10 seconds.
To Next Page
Loading...