27
To reinstall the lters, follow the same
procedures in reverse order.
To clean the ne and coarse lters, use a
cleaning brush. Then, mount the lter in the
Dishwasher, as in the images on the side.
The Dishwasher should never be used
without the lters. If the lters are not
properly placed, this may reduce the yield of
the appliance and damage the dishes.
Never turn on the Dishwasher if the lters
are not properly positioned.
Do not knock the lters while cleaning,
as this may bend them and degrade the
performance of the appliance.
Cleaning the door
To clean around the door, use only a damp
soft cloth. To prevent the penetration of
water into the door latch and the electrical
components, do not use aerosol type
cleaners of any type.
In addition, never use any abrasive cleaners
or rough sponges on the outside surfaces,
as they may damage the nish. Some types
of paper towels may also scratch or leave
markings on the surface.
Keeping the appearance of the
Dishwasher
After every washing:
The lter set should be
removed for cleaning at
least once per week.
OPEN
Cleaning and Maintenance
Cleaning the lters
For best performance and best results
in washing, the lter set must be always
clean.
The lter effectively removes food particles
from the rinse water, allowing the water to
recirculate during the cycle. Therefore, it is
necessary to remove the larger particles
of food retained in the lter after each
wash cycle by washing the main lter
(semicircular) and the glass in running
water.
Removing the lters
1 Rotate the thick lter counterclockwise
and lift it out.
2 Remove the lter set.
To Next Page
Loading...