9
Connection of the drain hose
Connect the drain hose to the Dishwasher, making sure that it is well t to avoid leaks.
Check if the drain hose is not kinked
or dented.
Place the other end of the drain hose
into a drain pipe with a minimum
diameter of 40 mm, or let it stand on
tank, avoiding that the hose is bent
or twisted. Use the special curve
provided with the appliance.
The free end of the hose must be at a
maximum height of 100 cm and must
not be immersed in water.
How to drain excess water from hoses
If the tank height is greater than 100 cm from the oor, the excess water in the hoses cannot
be drained directly into the tank.
It will be necessary to drain excess water from hoses into a container lower than the tank.
Connection of the cold water supply
Connect the hose of cold water supply to a faucet adapter with
¾” male thread, and make sure that there is no leak.
If the water hoses are new or have not been used for a long
period of time, let the water ow to ensure that the water comes
out clean and without impurities.
Connection of hot water
As long as the temperature does not exceed 50 °C, the water supply to the Dishwasher can
also be connected to a hot water line (centralised system, heating system).
In this case, the time of the wash cycle will be shorter.
Due to constructive restrictions of the machine, if the temperature exceeds this limit for a
certain period of time the door can open by itself.
The connection to the hot water line should be made in accordance with the same procedures
as the connection to the cold water supply.
Close the faucet after use.
Installation
Maximum 100 cm
To Next Page
Loading...