` ChannelA/BMemorySubTimings
This sub-menu provides memory timing settings for each channel of memory.
The respective timing setting screens
arecongurableonlywhenMemoryTimingMode is set to Manual or Advanced Manual.
Note: Your system
may become unstable or fail to boot after you make changes on the memory timings. If this occurs, please reset the
board to default values by loading optimized defaults or clearing the CMOS values.
` AdvancedVoltageSettings
` AdvancedPowerSettings
& CPU Vcore Loadline Calibration
AllowsyoutocongureLoad-LineCalibrationfortheCPUVcorevoltage.Selectingahigherlevelkeeps
the CPU Vcore voltage more consistent with what is set in BIOS under heavy load. Auto lets the BIOS
automaticallycongurethissettingandsetsthevoltagefollowingIntel'sspecications.(Default:Auto)
& VAXG Loadline Calibration
AllowsyoutocongureLoad-LineCalibrationfortheCPUVAXGvoltage.Selectingahigherlevelkeeps
the CPU VAXG voltage more consistent with what is set in BIOS under heavy load. Auto lets the BIOS
automaticallycongurethissettingandsetsthevoltagefollowingIntel'sspecications.(Default:Auto)
` CPUCoreVoltageControl
This section provides CPU voltage control options.
` ChipsetVoltageControl
This section provides Chipset voltage control options.
` DRAMVoltageControl
This section provides memory voltage control options.
` PC Health Status
& ResetCaseOpenStatus
Disabled Keeps or clears the record of previous chassis intrusion status. (Default)
Enabled Clears the record of previous chassis intrusion status and the CaseOpeneldwillshow
"No" at next boot.
& CaseOpen
Displays the detection status of the chassis intrusion detection device attached to the motherboard CI
header.Ifthesystemchassiscoverisremoved,thiseldwillshow"Yes",otherwiseitwillshow"No".To
clear the chassis intrusion status record, set ResetCaseOpenStatus to Enabled, save the settings to
the CMOS, and then restart your system.
& CPUVcore/CPUVCCSA/DRAMChannelA/BVoltage/+3.3V/+5V/+12V/CPUVAXG
Displays the current system voltages.
` MiscellaneousSettings
& Max Link Speed
Allows you to set the operation mode of the PCI Express slots to Gen 1, Gen 2, or Gen 3. Actual operation
modeissubjecttothehardwarespecicationofeachslot.AutoletstheBIOSautomaticallycongurethis
setting. (Default: Auto)
- 25 -