Gigabyte 5AX - Page 66

5AX
4-10
•
CPU Write Allocate
The default value is Enabled.
Enabled Set CPU Write Allocate to Enabled.
Disabled Set CPU Write Allocate to Disabled.
•
Quick Power On Self Test
This category speeds up Power On Self Test (POST) after you power on the
computer. If it set to Enable, BIOS will skip some check items during POST.
The default value is Enabled.
Enabled Enable quick POST.
Disabled Normal POST.
• Boot Sequence
This category determines which drive computer searches first for the disk
operating system (i.e., DOS). Default value is A, C, SCSI.
X1, X2, X3 System will first search for X1 disk drive then X2 disk drive
and then X3 disk drive.
•
VGA Boot From
The default value is PCI.
AGP System will boot from AGP Display Card
PCI System will boot from PCI VGA Card
• Swap Floppy Drive
The default value is Disabled.
Enabled Floppy A & B will be swapped under DOS.
Disabled Floppy A & B will be normal definition.