Gigabyte 5AX - Page 67

BIOS Configuration
4-11
• Boot Up Floppy Seek
During POST, BIOS will determine if the floppy disk drive installed is 40 or 80
tracks. 360 type is 40 tracks while 720 , 1.2 and 1.44 are all 80 tracks.
The default value is Enabled.
Enabled BIOS searches for floppy disk drive to determine if it is 40 or
80 tracks. Note that BIOS can not tell from 720, 1.2 or 1.44
drive type as they are all 80 tracks.
Disabled BIOS will not search for the type of floppy disk drive by track
number. Note that there will not be any warning message if
the drive installed is 360 .
•
Boot Up NumLock Status
The default value is On.
On Keypad is number keys.
Off Keypad is arrow keys.
•
Boot Up System Speed
The default value is High.
High Set Boot Up System Speed: High.
Low Set Boot Up System Speed: Low.
•
Gate A20 Option
The default value is Fast.
Fast Set Boot Up System Speed: High.
Normal Set Boot Up System Speed: Low.
•
Security option
The default value is Setup.
Setup The system will boot and access to Setup will be denied if
the correct password is not entered at the prompt.
System The system will not boot and access to Setup will be denied
if the correct password is not entered at the prompt.