Gigabyte G293-Z42-AAP1 - Page 113

BIOS Setup
- 113 -
DRAM Scrubbers
Press [Enter] to congure advanced items.

DRAM ECS Mode
– Options available: Auto, AutoECS, ManualECS, DisableECS.
Default setting is Auto.

DRAM Redirect Scrubber Enable
– Options available: Auto, Enabled, Disabled. Default setting is
Auto.

DRAM Scrub Redirection Limit
– Options available: Auto, 8 Scrubs, 4 Scrubs, 2 Scrubs, 1 Scrub.
Default setting is Auto.

DRAM Scrub Time
– Options available: Disabled, 1 hour, 4 hours, 6 hours, 8 hours,
12 hours, 16 hours, 24 hours, 48 hours. Default setting is 24
Hours.

DRAM Error Threshold Count
– Options available: Auto, ETC_4, ETC_16, ETC_64, ETC_256,
ETC_1024, ETC_4096. Default setting is Auto.

DRAM ECS Count Mode
– Options available: Auto, Row Count Mode, Code Word Count
Mode. Default setting is Auto.

DRAM AutoEcs during Self Refresh
– Options available: Auto, AutoEcs Disabled, AutoEcs Enabled.
Default setting is Auto.

DRAM ECS WriteBack Suppression
– Options available: Auto, Enable, Disable. Default setting is
Auto.
DRAM Corrected Error Counter
Enabled
Congure DRAM Corrected Error Counter function.
Options available: Disable, NoLeakMode, Leak Mode, Auto. Default
setting is Leak Mode.
DRAM Corrected Error Counter
Interrupt Enable
Enable SMI when DRAM corrected Error Counter count exceeds the
threshold value.
Options available: Disable, NoLeakMode, Leak Mode, Auto. Default
setting is Leak Mode.
DRAM Corrected Counter Leak
Rate
Program Rate value for DRAM Corrected Error Counter function.
Default setting is 7.
DRAM Corrected Error Counter
Start Count
Program starting value for DRAM Corrected Error Counter function.
Default setting is FFF5.