Gigabyte G293-Z42-AAP1 - Page 83

BIOS Setup
- 83 -
Parameter
Description
Device Conguration Menu
(continued)

Support RDMA
– Enable/Disable RDMA support for this port.
– Options available: Disabled, Enabled. Default setting is Disabled.

DCB Protocol
– Enable/Disable DCB protocol.
– Options available: Disabled, Enabled (IEEE only), CEE (only), Both
(IEEE preferred with fallback to CEE). Default setting is Disabled.

LLDP nearest bridge
– Enable/Disable LLDP nearest bridge state.
– Options available: Disabled, Enabled. Default setting is Enabled.

Default EVB Mode
– Congures the default Edge Virtual Bridging mode.
– Options available: VEB, VEPA, None. Default setting is VEB.

Enable PME Capability
– Enable/Disable PME Capability support.
– Options available: Disabled, Enabled. Default setting is Enabled.

Flow Ofoad
– Options available: Enabled, Disabled. Default setting is Disabled.

Live Firmware Upgrade
– Options available: Enabled, Disabled. Default setting is Disabled.

Adapter Error Recovery
– Options available: Enabled, Disabled. Default setting is Disabled.
MBA Conguration Menu
Press [Enter] to congure advanced items.

Option ROM
– Enable/Disable Boot Option ROM.
– Options available: Disabled, Enabled. Default setting is Enabled.

Legacy Boot Protocol
– Selects non-UEFI Boot Protocol: Preboot Execution Environment
(PXE)/iSCSI.
– Options available: PXE, iSCSI, NONE. Default setting is PXE.

Boot Strap Type
– Selects the boot strap type. Options available: Auto Detect, BBS,
Int 18h, Int 19h. Default setting is Auto Detect.

Hide Setup Prompt
– Congures whether the Setup Prompt is displayed during ROM
initialization.
– Options available: Disabled, Enabled. Default setting is Disabled.

Setup Key Stroke
– Congures key strokes to invoke the conguration menu.
– Options available: Ctrl-S, Ctrl-B. Default setting is Ctrl-S.

Banner Message Timeout
– Selects the timeout value. (0 defaults to 4 seconds, 15 is no delay,
1-14 is timeout value in seconds)
– Default setting is 5.