Gigabyte G293-Z42-AAP1 - Page 84

BIOS Setup
- 84 -
Parameter Description
MBA Conguration Menu
(continued)

Pre-boot Wake On LAN
– Congures Pre-boot Wake on LAN (WOL).
– Options available: Disabled, Enabled. Default setting is Enabled.

VLAN Mode
– Congures the virtual LAN (VLAN) mode.
– Options available: Disabled, Enabled. Default setting is Disabled.

VLAN ID
– Congures the VLAN ID (1…4094).
– This item is available only when VLAN Mode is Enabled.

Boot Retry Count
– Selects the number of boot retries.
– Options available: No Retry, 1 Retry, 2 Retries, 3 Retries, 4 Retries,
5 Retries, 6 Retries, Indenite Retries. Default setting is No Retry.
iSCSI Boot Conguration
Menu
Press [Enter] to congure advanced items.
Blink LEDs
Identies the physical network port by blinking the associated LED.
Press the numeric keys to adjust desired values.
Link Status
Species the link status of the port.
Physical Link Speed
Displays the technical specications for the Network Interface Controller.
Chip Type
Displays the technical specications for the Network Interface Controller.
PCI Device ID
Displays the technical specications for the Network Interface Controller.
Bus:Device:Function
Displays the technical specications for the Network Interface Controller.
Permanent MAC Address
Displays the MAC address of the Ethernet controller.
Virtual MAC Address
Displays the virtual MAC address of the Ethernet controller.
Restore Defaults
Resets the adapter to factory defaults.