Gigabyte G482-Z50 - Page 13

- 13 - Hardware Installation
Storage G482-Z50
 12 x 3.5" hot-swappable HDD/SSD bay
- Compatible with SATA/SAS devices only
10 x 2.5" hot-swappable HDD/SSD bay
- 8 x amber HDD tray compatible with NVMe or SATA/SAS device
- 2 x blue HDD tray compatible with SATA/SAS device only
 Pre-installed Broadcom SAS3008 storage adapter with IR mode and expansion
board
 Bandwidth: SATAIII 6Gb/s or SAS 12 Gb/s per port
G482-Z51
 10 x 2.5" SATA hot-swappable HDD/SSD bay
NOTE: SATA devices supported only
SAS/SATA  SAS supported
 SATA supported
Internal I/O  1 x TPM header
 1 x Front panel header
Front I/O  2 x USB3.0 connector
 1 x VGA connector
 2 x RJ45 LAN connector
 1 x MLAN connector (reserved, enabled by cable switch)
 1 x Power button with LED
 1 x ID button with LED
 1 x Reset button
 1 x NMI button
 1 x System status LED
 1 x HDD access LED
Rear I/O  2 x RJ45 LAN connector
 1 x MLAN connector (primary port)
Backplane I/O G482-Z50
 12 x 3.5" port and 10 x 2.5" port
G482-Z51
 10 x 2.5" port supporting SATA 6Gb/s
TPM  1 x TPM header with SPI interface
 TPM2.0 kit: CTM010 (optional)