Gigabyte GA-7IXE4 - CPU Speed Setup

7IXE4 Motherboard
7
CPU Speed Setup
The system bus frequency can be switched at 90MHz, 95MHz, 100MHz, 105MHz, 110MHz and
115MHz by adjusting SW1 (See Figure 1).
0
00
0
The CPU speed must match with the frequency RATIO. It will cause system hanging up if
the frequency RATIO is higher than that of CPU.
SW1: CPU Speed Setup
SW1
ON
1
2
3
4
90MHz
SW1
ON
1
2
3
4
95MHz
SW1
ON
1
2
3
4
100MHz
SW1
ON
1
2
3
4
105MHz
SW1
ON
1
2
3
4
110MHz
SW1
ON
1
2
3
4
115MHz
Figure 1



Note: Please set the CPU host frequency in accordance with your processor’s
specifications. We don’t recommend you to set the system bus frequency over
the CPU’s specification because these specific bus frequencies are not the
standard specifications for CPU, chipset and most of the peripherals. Whether
your system can run under these specific bus frequencies properly will depend
on your hardware configurations, including CPU, Chipsets, SDRAM,
Cards….etc.
0
AMD CPU Heat Sink Installation:
Beware: Please check that the heat sink is in good contact with the CPU before you turn on your
system.
The poor contact will cause over heat, and might cause damage to your
processor.