BIOS Setup
32
•
Try Other Boot Device
Yes Enabled other device to boot system.
(Default Value)
No Disabled other device to boot system.
•
Floppy
Access
Control
Read-Write Set Floppy Access Control: Read-Write.
(Default Value)
Read-Only Set Floppy Access Control: Read Only.
•
Hard Disk Access Control
Read-Write Set Hard Disk Access Control: Read-Write.
(Default Value)
Read-Only Set Hard Disk Access Control: Read Only.
•
••
•
Boot Up Num-Lock
On Keypad is number keys.
(Default Value)
Off Keypad is arrow keys.
•
Floppy Drive Swap
Enabled Floppy A & B will be swapped under DOS
Disabled Floppy A & B will be normal definition
(Default Value)
.
•
Floppy Drive Seek
During POST, BIOS will determine if the floppy disk drive installed is 40 or 80 tracks. 360 type
is 40 tracks while 720 , 1.2 and 1.44 are all 80 tracks.
Enabled BIOS searches for floppy disk drive to determine if it is 40 or 80 tracks.
Note that BIOS can not tell from 720, 1.2 or 1.44 drive type as they are
all 80 tracks.
Disabled BIOS will not search for the type of floppy disk drive by track number.
Note that there will not be any warning message if the drive installed is
360.
(Default Value)
To Next Page
Loading...
