Gigabyte GA-7IXE4 - Page 42

BIOS Setup
36
•
••
•
SDRAM CAS Latency
This function specify the delay from SCAS[2:0]# to data valid.
2 Cycles Set SDRAM CAS Latency to 2 Cycles.
3 Cycles Set SDRAM CAS Latency to 3 Cycles.
(Default value)
•
••
•
SDRAM TRCD Timing
This function specify the delay from the activation of a bank to the time that a read or write
command is accepted.
1 Cycle Set SDRAM TRCD Timing Value to 1 Cycle.
2 Cycle Set SDRAM TRCD Timing Value to 2 Cycle.
(Default value)
3 Cycle Set SDRAM TRCD Timing Value to 3 Cycle.
4 Cycle Set SDRAM TRCD Timing Value to 4 Cycle.
•
DRAM Integrity Mode
Disabled Disabled this function.
(Default Value)
ECC Set DRAM Integrity Mode to ECC.
•
Memory Hole
Disabled Normal Setting.
(Default Value)
14MB-15MB Set Address=14~15MB remap to ISA BUS.
15MB-16MB Set Address=15~16MB remap to ISA BUS.
14MB-16MB Set Address=14~16MB remap to ISA BUS.
•
DRAM Burst Refresh
Disabled Disabled this function.
Enabled Enabled DRAM Burst Refresh function.
(Default Value)