Gigabyte GA-A75N-USB3 - Memory Clock; Dram Configuration

BIOS Setup - 34 -
DRAM E.O.C.P &
Allows you to determine whether to use the preset memory overclocking prole to achieve optimum
overclocking performance. (Default: Disabled)
Set Memory Clock &
Determines whether to manually set the memory clock. Auto lets BIOS automatically set the memory clock
as required. Manual allows the memory clock control item below to be congurable. (Default: Auto)
Memory Clock &
This option is congurable only when Set Memory Clock is set to Manual.
X5.33 Sets Memory Clock to X5.33. 
X6.66 Sets Memory Clock to X6.66. 
X8.00 Sets Memory Clock to X8.00. 
X9.33 Sets Memory Clock to X9.33. 
DRAM Conguration &
CMOS Setup Utility-Copyright (C) 1984-2011 Award Software
DRAMConguration
DDR3 Timing Items [Auto] SPD Auto
x 1T/2T Command Timing Auto -- --
x CAS# latency Auto 9T 9T
x RAS to CAS R/W Delay Auto 9T 9T
x Row Precharge Time Auto 9T 9T
x Minimum RAS Active Time Auto 24T 24T
x TwTr Command Delay Auto 5T 5T
x Trfc0 for DIMM2 Auto 110ns 110ns
x Trfc1 for DIMM1 Auto -- --
x Write Recovery Time Auto 10T 6T
x Precharge Time Auto 5T 4T
x Row Cycle Time Auto 33T 20T
x RAS to RAS Delay Auto 4T 4T
x Four Bank Activate Windows Auto -- --
**DCTs Drive Strength** DCT0 DCT1
Proc0dt (ohms) [Auto] 60 [Auto] 240
DQS Drive Strength [Auto] 1.0x [Auto] 1.5x
Data Drive Strength [Auto] 1.0x [Auto] 1.5x
MEMCLK Drive Strength [Auto] 1.25x [Auto] 1.5x
hi
: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level

CMOS Setup Utility-Copyright (C) 1984-2011 Award Software
DRAMConguration
Addr/Cmd Drive Strength [Auto] 1.5x [Auto] 2.0x
CS/ODT Drive Strength [Auto] 1.5x [Auto] 2.0x
CKE Drive Strength [Auto] 1.5x [Auto] 2.0x
**DCTs Addr/Cmd Timing** DCT0 DCT1
Addr/Cmd Setup Time [Auto] 1T [Auto] 1/2T
Addr/Cmd Fine Delay [Auto] 22/64 [Auto] 0/64
CS/ODT Setup Time [Auto] 1/2T [Auto] 1/2T
CS/ODT Fine Delay [Auto] 0/64 [Auto] 0/64
CKE Setup Time [Auto] 1/2T [Auto] 1/2T
CKE Fine Delay [Auto] 0/64 [Auto] 0/64
Bank Interleaving [Enabled]
hi
: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level
