BIOS Setup - 40 -
First/Second/Third Boot Device &
Species the boot order from the available devices. Use the up or down arrow key to select a device and
press <Enter> to accept. Options are: LS120, Hard Disk, CDROM, ZIP, USB-FDD, USB-ZIP, USB-CDROM,
USB-HDD, Legacy LAN, Disabled.
Password Check &
Species whether a password is required every time the system boots, or only when you enter BIOS Setup.
After conguring this item, set the password(s) under the Set Supervisor/User Password item in the BIOS
Main Menu.
Setup A password is only required for entering the BIOS Setup program. (Default)
System A password is required for booting the system and for entering the BIOS Setup
program.
HDD S.M.A.R.T. Capability &
Enables or disables the S.M.A.R.T. (Self Monitoring and Reporting Technology) capability of your hard
drive. This feature allows your system to report read/write errors of the hard drive and to issue warnings
when a third party hardware monitor utility is installed. (Default: Disabled)
Away Mode &
Enables or disables Away Mode in Windows XP Media Center operating system. Away Mode allows the
system to silently perform unattended tasks while in a low-power mode that appears off.
(Default: Disabled)
Full Screen LOGO Show &
Allows you to determine whether to display the GIGABYTE Logo at system startup. Disabled displays
normal POST message. (Default: Enabled)
Init Display First &
Species the rst initiation of the monitor display from the installed PCI graphics card, PCI Express graphics
card, or the onboard graphics.
Onboard Sets the onboard graphics as the rst display.
PCI Slot Sets the PCI graphics card on the PCI slot as the rst display.
PEG Sets the PCI Express graphics card on the PCIEX16 slot as the first display.
(Default)
To Next Page
Loading...
