Gigabyte GA-A75N-USB3 - Page 68

Appendix - 68 -
The BIOS Setup menus described in this section may differ from the exact settings for your mother-
board. The actual BIOS Setup menu options you will see shall depend on the motherboard you have
and the BIOS version.
Item Help
Menu Level

Step 2:
Save changes and exit BIOS Setup.
Figure 1
B. Conguring SATA controller mode in BIOS Setup
Make sure to congure the SATA controller mode correctly in system BIOS Setup.
Step 1:
Turn on your computer and press <Delete> to enter BIOS Setup during the POST (Power-On Self-Test). Make
sure OnChip SATA Controller is enabled. To enable RAID for the SATA3_0/1/2/3 connectors, set OnChip
SATA Type to RAID. To enable RAID for the eSATA connector, set OnChip SATA Type to RAID and set
OnChip SATA Port4 Type to As SATA Type (Figure 1).
CMOS Setup Utility-Copyright (C) 1984-2011 Award Software
Integrated Peripherals
OnChip SATA Controller [Enabled]
OnChip SATA Type [RAID]
OnChip SATA Port4 Type [As SATA Type]
x OnChip SATA Port as ESP Press Enter
Onboard LAN Function [Enabled]
Onboard LAN Boot ROM [Disabled]

SMART LAN [Press Enter]
Onboard Audio Function [Enabled]
Onchip USB 3.0 Controller [Enabled]
USB Controllers [Enabled]
USB Legacy Function [Enabled]
USB Storage Function [Enabled]
hi
: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level
