Gigabyte GA-B75M-D3P - Parallel Port

- 38 -
When set to Enabled, the following two items will appear.
& PLDM for SMBIOS
 AllowsyoutodeterminewhethertosendBIOSinformation,theCPUspeeds,memorysize,etc.,tothe
RealtekManagementConsoleUtility.(Default:Enabled)
& PLDMforBIOSControlandConguration
 AllowsyoutodeterminewhethertosetbootorderintheRealtekManagementConsoleUtility.(Default:
Enabled)
` SuperIOConguration
 ThissectionprovidesinformationonthesuperI/Ochipandallowsyoutoconguretheserialportand
parallel port.
& Serial Port A/B
 Enablesordisablestheonboardserialport.(Default:Enabled)
& Parallel Port
 Enablesordisablestheonboardparallelport.(Default:Enabled)
` Intel(R) Smart Connect Technology
& ISCTConguration
 EnablesordisablesIntelSmartConnectTechnology.(Default:Disabled)
` MarvellATAControllerConguration
& GSATA Controller (Marvell 88SE9172 Chip, GSATA3 6 and GSATA3 7 connectors)
 EnablesordisablesRAIDfortheSATAcontrollersintegratedintheMarvell88SE9172chiporcongures
the SATA controllers to AHCI mode. The area below displays the current status of the two SATA ports.
IDEMode  DisablesRAIDfortheSATAcontrollersandcongurestheSATAcontrollerstoIDE
mode.(Default)
AHCIMode CongurestheSATAcontrollerstoAHCImode.AdvancedHostControllerInterface
(AHCI)isaninterfacespecicationthatallowsthestoragedrivertoenableadvanced
Serial ATA features such as Native Command Queuing and hot plug.
RAID Mode Enables RAID for the SATA controllers.
Disabled Disables this function.