Gigabyte GA-E350N-USB3 - Page 11

- 11 - Hardware Installation
Internal
Connectors
1 x 24-pin ATX main power connector 
1 x 4-pin ATX 12V power connector 
4 x SATA 6Gb/s connectors 
1 x CPU fan header 
1 x system fan header 
1 x front panel header 
1 x front panel audio header 
1 x S/PDIF Out header 
2 x USB 2.0/1.1 headers 
1 x debug card header 
* This port is mainly used by repair technicians for debugging and problem
diagnosis.
1 x chassis intrusion header 
1 x power LED header 
1 x clearing CMOS jumper 
Back Panel
Connectors
1 x PS/2 keyboard/mouse port 
1 x D-Sub port 
1 x DVI-D port 
1 x optical S/PDIF Out connector 
1 x HDMI port 
4 x USB 2.0/1.1 ports 
2 x USB 3.0/2.0 ports 
1 x RJ-45 port 
6 x audio jacks (Center/Subwoofer Speaker Out/Rear Speaker Out/Side Speaker 
Out/Line In/Line Out/Microphone)
I/O Controller iTE IT8720 chip 
Hardware
Monitor
System voltage detection 
CPU/System temperature detection 
CPU/System fan speed detection 
BIOS 2x16Mbitash 
Use of licensed AWARD BIOS 
Support for DualBIOS 
™
PnP 1.0a, DMI 2.0, SM BIOS 2.4, ACPI 1.0b 