Gigabyte GA-E350N-USB3 - Startup Screen

BIOS Setup - 28 -
2-1 Startup Screen
The following screens may appear when the computer boots.
Function Keys:
<DEL>: BIOS SETUP\Q-FLASH
Press the <Delete> key to enter BIOS Setup or to access the Q-Flash utility in BIOS Setup.
<F9>: XPRESS RECOVERY2
If you have ever entered Xpress Recovery2 to back up hard drive data using the driver disk, the <F9>
key can be used for subsequent access to Xpress Recovery2 during the POST. For more information,
refer to Chapter 4, "Xpress Recovery2."
<F12>: BOOT MENU
 BootMenuallowsyoutosettherstbootdevicewithoutenteringBIOSSetup.InBootMenu,usetheup
arrow key <
h
> or the down arrow key <
i
>toselecttherstbootdevice,thenpress<Enter>toaccept.
ToexitBootMenu,press<Esc>.ThesystemwilldirectlybootfromthedeviceconguredinBootMenu.
Note: The setting in Boot Menu is effective for one time only. After system restart, the device boot order
willstillbebasedonBIOSSetupsettings.YoucanaccessBootMenuagaintochangetherstbootde-
vice setting as needed.
<END>: Q-FLASH
 Pressthe<End>keytoaccesstheQ-FlashutilitydirectlywithouthavingtoenterBIOSSetuprst.
Motherboard Model
BIOS Version
Function Keys
Award Modular BIOS v6.00PG
Copyright (C) 1984-2010, Award Software, Inc.
GA-E350N-USB3 D20
.
.
.
.
<DEL>: BIOS Setup <F9>: XpressRecovery2 <F12>: Boot Menu <End>: Qflash
12/29/2010-Zacate-Hudson-7A66EG01C-00